NTEK Systems Support
Would you like to react to this message? Create an account in a few clicks or log in to continue.

1st wiring diagram on the manual does not work.

2 posters

Go down

1st wiring diagram on the manual does not work. Empty 1st wiring diagram on the manual does not work.

Post by philsec Mon Jan 16, 2017 9:24 am

Good day!

Tried to install my witlock but found that the 1st wiring diagram on the manual does not work. Are there any updates to this?

philsec

Posts : 20
Join date : 2016-12-05

Back to top Go down

1st wiring diagram on the manual does not work. Empty Re: 1st wiring diagram on the manual does not work.

Post by freedomz007 Wed Jan 18, 2017 9:34 am

Hello philsec

On behalf of my company we would like to apologize if you encountered the reported issue

The manual provided with the Witlock is missing some notes for the Figure 8.1
For Figure 8.1 to work, you need to enable on board Dip switch in witlock
1. Open the witlock device
2. Enable dip switch
3. Close the witlock device

Here's the image of the DIP switch you need to enable
1st wiring diagram on the manual does not work. Dip_sw10


Right now we are revising the manual, that will be available on our website for download

freedomz007

Posts : 6
Join date : 2016-12-13

Back to top Go down

1st wiring diagram on the manual does not work. Empty Re: 1st wiring diagram on the manual does not work.

Post by philsec Wed Jan 18, 2017 10:19 am

Thanks for this freedomz!

philsec

Posts : 20
Join date : 2016-12-05

Back to top Go down

1st wiring diagram on the manual does not work. Empty Re: 1st wiring diagram on the manual does not work.

Post by philsec Sun Jan 29, 2017 11:44 am

Which of the four switch should I enable? Or should it be all?

philsec

Posts : 20
Join date : 2016-12-05

Back to top Go down

1st wiring diagram on the manual does not work. Empty Re: 1st wiring diagram on the manual does not work.

Post by freedomz007 Mon Jan 30, 2017 8:57 am

Good day,

Each switch corresponds with sensors 1-4, so if you only used the 1st wiring on Sensor 1, you only need to enable switch 1.

freedomz007

Posts : 6
Join date : 2016-12-13

Back to top Go down

1st wiring diagram on the manual does not work. Empty Re: 1st wiring diagram on the manual does not work.

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum